New PM 932M-PDF arrival

PXL_20210914_203056244.jpg
 
decided to install a budget DRO system. will be installing covers on the scales.
yes,
t.jpg
tt.jpg
ttt.jpg
tttt.jpg

I know a real set up has lots of advantages over this :)
 
Last edited:
as usual when you drill on these chinese machines. actually, in this case it was just from blowing the threaded hole out with air. I bet I have 15 of these chunks missing. came with at least 10 of them. this is just one. gotta be 1/8 in of "putty".

ttttt.jpg
tttttt.jpg
 
nod is off half a thou. would you mess with this?
So wouldn't it be true to say, even if it was worse (2 tho); Mount some type of mic 6 (stress free cast aluminum w/ ground finish), or similar, top plate and skim cut it to align with the nod. It would then be perfectly true to itself.

Maybe you'd never get the full table covered with it but certainly enough cover/perform 95% use cases.

Sent from my SM-G960U using Tapatalk
 
Back
Top