Machinist Tool Chest #1 Tour

[erikmannie]

Lathe tools:

 

[erikmannie]

Dial test indicator drawer, depth micrometer, dead blow hammer:

 

[erikmannie]

“Angles” drawer: machinist square, sine bar, protractor, angle and 1-2-3 blocks:

 

[erikmannie]

Inside micrometers, 6-7” outside mic and 0-1” screw thread mic, imperial standards:

 

[erikmannie]

Transfer punches, drill chucks and drills:

 

[erikmannie]

My 0-6” outside mics are in a separate box:

 

[Aukai]

Very well done, you can see the bottom of the drawers,,,,,,,,sooooo you don't have enough tools it looks like The proper (well known) authorities will be along to encourage you

 

[erikmannie]

Very well done, you can see the bottom of the drawers,,,,,,,,sooooo you don't have enough tools it looks like The proper (well known) authorities will be along to encourage you

At this point, I have run my family’s finances into the ground buying machines & tools. My wife had a little to say about it today.

I told her that now I never need to go anywhere, and it is good clean fun. She asked very nicely for me to give it a rest for awhile.

 

[mmcmdl]

Very well done, you can see the bottom of the drawers,,,,,,,,sooooo you don't have enough tools it looks like The proper (well known) authorities will be along to encourage you

You rang Mike ? Looks like a starter set to me , I say we load 'em up !

 

[Nutfarmer]

I noticed several Shars tools. How do you like them in general. I have never used them ,but the price is attractive.