Lathe Stepper Motor Power Feed Mod

Ohh so we have been mortal enemies lmao, I was a test engineer in charge of signing off NPI on a third generation product. Might have angered a designer or two by constantly requesting board revisions to add coverage for flying probe :x, but in fairness it did pay off once production ramped up and we all played nice together lol
Recently I was contracted to develop and deliver a test fixture for a lab in 8 weeks or less. Wish I had known about your PCB service then but I’m honestly amazed the breadboard protoboard is still holding up after 6 months
JLCPCB is an off shore PCB manufacturer. I am not affiliated with them in any way. I simply used them for this board. I designed my own custom PCB using open source KiCAD. KiCAD was able to create all the files that JLCPCB needed. I'm not a professional PCB designer, just someone that taught myself enough to get this board done. I'm a rank amateur, really. Stubborn perhaps, but with enough tenacity to get the job done.
 
JLCPCB is an off shore PCB manufacturer. I am not affiliated with them in any way. I simply used them for this board. I designed my own custom PCB using open source KiCAD. KiCAD was able to create all the files that JLCPCB needed. I'm not a professional PCB designer, just someone that taught myself enough to get this board done. I'm a rank amateur, really. Stubborn perhaps, but with enough tenacity to get the job done.
Yes I gathered, the service you recommended was rather my meaning. And It’s the rank amateurs who have the tenacity the professionals get beaten out of them by project managers in my experience!
 
Back
Top