Jig Blueprints

[GunsmithD]

Gunsmithing Moderators, can we make a sticky for jig blueprints?


Here is a blueprint for a bolt jeweling jig from Brownells. I had the side plates redrawn, they are separate. The sliding shaft and tie rod have break lines on the end instead of the middle. Don't let that throw you off when reading it.

 

[GoMopar440]

There's a downloads tab up near the top of the page with a gunsmithing sub-section that would be a good place to put those drawings.

Here's the link: http://www.hobby-machinist.com/vbdownloads.php?categoryid=28