Introducing "Boat Anchor", an Atlas MHC Mill restoration (almost)

Atlas2start · May 23, 2020

jster1963 said:
Just beautiful! I just restored a MFC on YouTube. I may post pictures of mine too. Great job.....

Please, post your YouTube link here, I would love to see it!

jster1963 · May 23, 2020

Atlas2start said:
Please, post your YouTube link here, I would love to see it!

This is part 7. It shows it mostly done. Part 8 shows chips, but it's a longer video (27 mins).

Atlas2start · May 23, 2020

jster1963 said:
This is part 7. It shows it mostly done. Part 8 shows chips, but it's a longer video (27 mins).

Yours came out great! I will have to remember the hammer tone paint.

jster1963 · May 26, 2020

Atlas2start said:
Yours came out great! I will have to remember the hammer tone paint.

Thank you so much! I wasn't sure if I would like the hammered finish, but when it was done...it grew on me. And thank you again......

Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!