-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
If You Were To Start Over
- Thread starter boostin53
- Start date
- Joined
- Sep 11, 2015
- Messages
- 293
No not that I have noticed. I already have them in my garage/shop.
- Joined
- Dec 6, 2012
- Messages
- 2,709
Hacksaw, file, 1" bench mic, Anderson HSS hand scraper, stone, machinist vise, surface plate.
A single good learning text or even better, a local mentor who growled "not good enough".
Learn the basics and everything else makes sense.
I jumped ahead and trying to regress.
Daryl
MN
A single good learning text or even better, a local mentor who growled "not good enough".
Learn the basics and everything else makes sense.
I jumped ahead and trying to regress.
Daryl
MN
4
4GSR
Forum Guest
Register Today
Boostin,
Back about 20 years ago, I lived in Mansville, just south of there but worked over there near Ranger Stadium area. About every week or two, I would make a trip up and down Division street between 360 and Grandview hitting every palm shop there was back then, for about two to three blocks north and south of Division st. I picked up lots of stuff, most of it came from area manufactures around there. Most of the palm shops didn't know what they had there and could be had for pennies on the dollar. Just another thought to share.
Back about 20 years ago, I lived in Mansville, just south of there but worked over there near Ranger Stadium area. About every week or two, I would make a trip up and down Division street between 360 and Grandview hitting every palm shop there was back then, for about two to three blocks north and south of Division st. I picked up lots of stuff, most of it came from area manufactures around there. Most of the palm shops didn't know what they had there and could be had for pennies on the dollar. Just another thought to share.
- Joined
- Sep 23, 2010
- Messages
- 619
Well I have been a pack rat for 40 years gathering tooling I see. Even if I can't use it yet. I can't really say anything that I haven't found as I am still using 40 year old HSS tool bits I had in high school. Some of the tooling I use now wasn't around 40 years ago like my ER40 collet chuck but I am sure the collets were used in a mill. I have about 8 of everything, drill chucks, lathe chucks, centers...Bob
I remember using old Vienna Sausage tins. I was wondering the name of those container I have seen in a few photos.
