Fusion 360 from the start

B

BROCKWOOD

H-M Supporter - Gold Member
H-M Supporter Gold Member
Joined
May 26, 2017
Messages
962
I'm a go to try Fusion 360. This from a lad that has been given advanced graphic artist programs (2D) & eschewed them - much preferring the simple Paint program. There was nothing intuitive about them. But I have a need to design a simple clamp holding kit out of sheet metal. I have carefully sketched my needs & noted the measurements. But, I need to see this thing in 3D to tweak it & ensure the measure twice & bend once rule.

So far I'm at a loss for why the program hasn't installed correctly & started on it's own.

Updates as I learn what to do....................
 
This is a simple Paint picture I made of a bass guitar electronics setup. No stranger to complicated stuff - but still feel like an old dog with this newer tech.
 

Attachments

  • 78 80102 626.jpg
    78 80102 626.jpg
    1.9 MB · Views: 37
They say, "Allow 30 minutes for the download to begin." Still nothing at the 47 minute mark. I'll have to try again later.
 
Thanks Nutfarmer. & you're right. But, I'm shaky on sheet metal bending so...

I did find an email from them & answered all their personal questions. Life story really.

If I were a comedian, I'd liken it to:
1. Have you watched "Debbie Does Dallas"?
NO
2. Did you enjoy "Debbie Does Dallas"?
Now that's a bit presumptuous isn't it?!

I created a sign on & a password (Nothing to do with Debbie or Porn OK). Still no access as of yet & approaching the 2 hr mark.
 
Nah JfF. Paying for the fastest cable internet in the land. I have recently been forced to submit to a Windows 10 upgrade - which isn't an upgrade at all really. This might prove to be the entire problem. Time will tell & the nut behind the wheel (me) is always suspect.

But, hey, this is why I am sharing this adventure.
 
Nutfarmer said:
I admire your tenacity. I have given up with the cad programs a long time ago. For most of what I do I can draw it before the computer loads the program.
Click to expand...
You and me both Steve.
I just can’t figure it out.
 
Easiest one I've ever used. Just have to get used to thinking about the design process in it's terms I guess.
 
You must log in or register to reply here.
Back
Top