DRO Z Axis Question.

[RandyWilson]

Do you remember which setting? The manual that came with my newest DRO isn't too bad.

 

[RandyWilson]

Best guess, looking through the manual, would be "Z-Dial". This would be set if you wanted to do 3 -axis work, but only have two scales, X and Y. It is programmed to match your hand wheel calibration. In your picture above, it would mean 3 full turns of the Z axis plus an additional 5.0 units.

 

[Practicable Solution]

there's a few tutorials on youtube for the ToAuto DRO's that I've found useful