Put your stuff in the cart and see what the shipping is. I think in total I was around $780 to my door with 3 mag scales, one upgraded to 1 micron… all depends on how you configure it. Still about $200-$300 cheaper than anything else
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
DRO advice for lathe?
- Thread starter skcncx
- Start date
TouchDRO with glass scales you will not regret it!
This is my install if I'm excused for posting a link.
www.stockholmviews.com
And here is Yuri's official website: https://www.touchdro.com/store/
This is my install if I'm excused for posting a link.
stockholmviews.com
DIY photography, IOT, Arduino, ESP, Range Rover P38's and much more.
www.stockholmviews.com