Cutting Oil Container

[Rata222]

Hi All. - Hope this is OK to share here.
Here is a link to a post a I made a few years ago on another forum of some No Spill cups I made from PVC couplings. They were cheap and easy to make. Work great. I am still using them today.

https://www.practicalmachinist.com/...roof-cutting-oil-container-easy-cheap-326729/

 

[jdedmon91]

Hi All. - Hope this is OK to share here.
Here is a link to a post a I made a few years ago on another forum of some No Spill cups I made from PVC couplings. They were cheap and easy to make. Work great. I am still using them today.

https://www.practicalmachinist.com/...roof-cutting-oil-container-easy-cheap-326729/

That’s inexpensive enough


Sent from my iPad using Tapatalk

 

[jdedmon91]

I’m going to see if I can figure a way to mount a PVC pipe in one of them. After I seen your post, it made me think. The paint cups are approximately $2 per cup, plus the 1/2 PVC pipe and a coupling. I now just machine the coupling down to fit the hole in the lid and epoxy it to the cup. My experiment is to use the containers I found 3 for a $1 at a dollar store and mount a pipe in the lid like soldering a copper pipe to a can.

If it works I do a video


Sent from my iPad using Tapatalk

I did it today and here is the video

Sent from my iPad using Tapatalk

 

[9t8z28]

I have a Spillmaster I threw a neodymium magnet in the container to keep it put and help keep chips out of the brush.

This is exactly what I do. Works perfect.

 

[9t8z28]

Very entertaining video! Subscribed!

I did it today and here is the video

Sent from my iPad using Tapatalk

 

[kd4gij]

You can get these at a dollar store for well a dollar. Silicone the top and they work great

 

[AGCB97]

Another one filed under the "Poor Folks do it the Poor Way".
I use an old empty Tuna can with a .15 cent acid brush. It rides on my crossfeed and if I do knock it off I only lose about an ounce of fluid. My cutting oil is 50/50 mix of ATF and Kerosene.
**G**

Ditto and these brushes https://www.harborfreight.com/12-in...<$10&msclkid=e970311568ab160142686f4bbcf6ce50

Aaron