Calibrate A Cheap Chinese Dro

[MSD0]

Yea, it's poorly translated for sure, but at least they show you what buttons to press. It looks like the resolution and linear compensation are covered on pages 43-44.

 

[pav138]

Thanks for the offer brino but I was able to do it

HI
Could you please tell me how to switch this GCS900-2D from milling to Lathe operation

 

[AGCB97]

I know this is an old post and would not normally post to it at this point but since it's on top now. I just checked the calibration a few days ago with a 123 block and it's off by .001 in 3"

 

[MSD0]

You can try using the linear compensation to correct the error.

 

[AGCB97]

You can try using the linear compensation to correct the error.

Well 1st off I think .001 in 3" is well within my tolerance expectations but I do not understand your statement.

Thanks
Aaron

 

[Kernbigo]

i check mine by using gage block set up 7" and was out only .001

 

[MSD0]

Well 1st off I think .001 in 3" is well within my tolerance expectations but I do not understand your statement.

Thanks
Aaron

No problem, I wasn't sure if you were asking a question.