Angle cut

[francist]

Does this make it clearer? I'm assuming you have a disc sander for your woodworking, so by dropping the table 30 degrees off 90 you could take half the width of one face off from two opposing sides of your 1/2 X 1/2 block and end up with a 120 degree ridge in the centre. Like this:



-frank

 

[Maplehead]

Does this make it clearer? I'm assuming you have a disc sander for your woodworking, so by dropping the table 30 degrees off 90 you could take half the width of one face off from two opposing sides of your 1/2 X 1/2 block and end up with a 120 degree ridge in the centre. Like this:

View attachment 277549

-frank

Before you replied here I got your idea but what I did was make a 30 degree wood wedge to use for the metal piece.
Now, with your drawing clearly stating what you meant, I am incredibly embarassed to say that yes, I do have that sander, yes, it does swivel with degree markings, and no, I didn’t even know that. Lol

 

[WarrenP]

Remember your sander markings probably aren't perfectly accurate. Better check the angles.