- Joined
- May 7, 2014
- Messages
- 776
Re: Update #3 Air pencil engraver mount for CNC mill.
Hi Arlo, Thanks for the reply. I did recheck the Hershey/inkscape to gCode run today. It was a bad feedrate setting on my end it seems. It is now only a 9 min run now while setup correctly. thanks for asking and helping. I thought it seemed odd but had too much going on all at once. Appreciate the heads up w/ your findings too! looking forward to some new bits from the source Jim noted. I hope to try my hand engraving some steel pretty soon. Been a lot of fun and an adventure thus far.
CG.
Hi Arlo, Thanks for the reply. I did recheck the Hershey/inkscape to gCode run today. It was a bad feedrate setting on my end it seems. It is now only a 9 min run now while setup correctly. thanks for asking and helping. I thought it seemed odd but had too much going on all at once. Appreciate the heads up w/ your findings too! looking forward to some new bits from the source Jim noted. I hope to try my hand engraving some steel pretty soon. Been a lot of fun and an adventure thus far.
CG.