- Joined
- Dec 22, 2020
- Messages
- 30
I recently picked up a 70’s luxcut lathe. The lathe can be wired either 110v or 220v and had the diagram to wire both ways in the manual; neither of which jive with the way it’s wired now so I’m going to do a full reset and confirm it’s correct from the plug out.
So the age old debate question, should I go 110 or 220? 110 would be far easier for me but I can do 220.
And secondly, if I go 110 I’m assuming a dedicated 20amp circuit with 12 gauge wire would be the way to go?
So the age old debate question, should I go 110 or 220? 110 would be far easier for me but I can do 220.
And secondly, if I go 110 I’m assuming a dedicated 20amp circuit with 12 gauge wire would be the way to go?