Complete Gear Cutting and Dividing Plate Spreadsheet Version 7

I was cutting a gear and had the number of holes wrong. I put in a picture showing how to use number of holes.

The depth of cut was too deep and has been fixed.

I have converted the inexact plate sheet from decimal to degrees, minutes, seconds. This will allow cutting gears without dividing plates and allow a better check on where your dividing plate is.

I used a macro for the conversion, so you must allow macros.

I made the third sheet easier to read and made the first sheet easier to find.

I have added both tooth position, and tooth width error in selecting the best dividing plate number when dividing plates don't work out exactly.

I had total number of holes on Page 3. Should have had the remainder holes after turns.