I have this Dayton gear reduction motor I want to wire for 110v. I pictured the wiring diagram and the electrical box that is attached to the motor.
According to the diagram, do I simply wire nut the white, red and purple to the common and the other three to the hot power wire? Seems like an awful lot of wires just to wire nut all together? I will probably use an old computer power cable for power. The ground lead, I can handle, lol.
I also want to wire in a two prong toggle switch that is rated for 110v. Do I simply break the hot lead with the switch?
As you can tell, I'm no electrician, lol.
According to the diagram, do I simply wire nut the white, red and purple to the common and the other three to the hot power wire? Seems like an awful lot of wires just to wire nut all together? I will probably use an old computer power cable for power. The ground lead, I can handle, lol.
I also want to wire in a two prong toggle switch that is rated for 110v. Do I simply break the hot lead with the switch?
As you can tell, I'm no electrician, lol.