O
ome
Forum Guest
Register Today
I am looking to buy a 8 or 10 inch rotary table for my new mill. My Z height is only 17 inches. I would like to keep the weight under 75 ibs.
Palmgreen sells a 10 inch is 3 and 7/8" high.center bore of 1 and 5/8", and a table size of 9.5" by 12".weighs only52 lbs.
the only other one is made by southbend, and is much heavier at 94 lbs and a #3 socket.
Any suggestions would be appreciated. The only negative i heard on the phase II leaking oil when put on the vertical positions
Thanks,
jon
Palmgreen sells a 10 inch is 3 and 7/8" high.center bore of 1 and 5/8", and a table size of 9.5" by 12".weighs only52 lbs.
the only other one is made by southbend, and is much heavier at 94 lbs and a #3 socket.
Any suggestions would be appreciated. The only negative i heard on the phase II leaking oil when put on the vertical positions
Thanks,
jon