- Joined
- Mar 14, 2013
- Messages
- 736
Ya, me too... nope, it only runs forward... direct power or through PWM.
maybe there is something wrong with the board.
Ya, me too... nope, it only runs forward... direct power or through PWM.
I want to power the lead screw on my Logan lathe, as I have no QCGB, and of course, will go back to the gears if I want to do any threading.
I have this controller, but don't know a lot about it, I need to know if anyone knows what motor I need to use this controller.
I am pretty sure this is a PWM controller, as talked about in this thread.
anyone know anything about this controller.
Google search did not come up with too much, although I am still looking.
here is the pictures of the controller.
it is 120 Volt input.
Jim, I don't suppose I could use this on my 110 V Drill press motor?
The one you said was for a fan?
Yeah, maybe tomorrow, I will take a ride and pick up the motor.
Then I need to get a controller. Guess I will have to buy a pot, but won't need the dpdt switch this time for the DP, as I won't need reverse.