- Joined
- Mar 14, 2013
- Messages
- 736
I want to power the lead screw on my Logan lathe, as I have no QCGB, and of course, will go back to the gears if I want to do any threading.
I have this controller, but don't know a lot about it, I need to know if anyone knows what motor I need to use this controller.
I am pretty sure this is a PWM controller, as talked about in this thread.
anyone know anything about this controller.
Google search did not come up with too much, although I am still looking.
here is the pictures of the controller.
it is 120 Volt input.
I have this controller, but don't know a lot about it, I need to know if anyone knows what motor I need to use this controller.
I am pretty sure this is a PWM controller, as talked about in this thread.
anyone know anything about this controller.
Google search did not come up with too much, although I am still looking.
here is the pictures of the controller.
it is 120 Volt input.
Phil
As allready mentioned, wiper motors, power window motors, power seat motors could be possible. It probably will be a load thing as to how hot they will run. As far as I know, window & seat motors are for intermitant use, and could be a hit and miss as to what brand will do the job.
Ive allready mentioned stepper motors, and are available for most any application you could think of for a lathe. In the USA and Canada they are not super expensive either.
http://www.kelinginc.net/ for steppers and power supply.
http://sdp-si.com/ for the timing belts/ pulleys, and couplers