I'm not good with electronics or wiring. 6-12 volt DC yes everything else no. The motor on the Millrite is 110/220 a electrician I know is going to wire it 220 for me (I keep his old BMW motorcycle running he does my electrical work). It's a belt drive is it possible to add VFD or some type of speed control to my mill. I normally run about 1160 rpm. Could run faster for brass and aluminum, just too lazy to change pulleys. It's a real pain when I want to use the co-ax indicator. Any help or suggestions would be appreciated. If this has been covered in another post please point me in that direction. Thanks. Roger