Update On Atlas Qc42 Reserection

[Bill Rosselot]

I thought I would post some progress and set backs As you can see in this picture took the Pulley assembly out of the degreaser and found this broken will need to weld it back together but as everyone know Cast is tricky to weld but I've done it and know the procedure. Still waiting for parts and have most everything ordered, should have it complete in about a week or two.

 

[yendor]

I would have it Brazed. Cast Brazes better than it welds.
That is not a super stress area. If you have the belt so tight it would break a properly done brazing joint then it's too tight.