- Joined
- Dec 2, 2016
- Messages
- 238
I do know the make which is an Acme transformer.
But how would I go about testing it without causing too much damage to soft tissue. H1,H2,H3 are all connected to winding #3 if I understand correctly.
It was given to me with a machine which has 380V motors ion it. Supposedly run from 220V 3 PH power supply. This last part I am not entirely sure of though.
X1,X2,X3 and Ground RED,BLACK,BLUE,GREEN) are from the original supply source on the primary coil.
Could it be #71 page 40 of this manual just run backwards as this shows X1,X2,X3 on # 3 instead of how its wired now on HQ,H2,H3 on #3?
https://hubbellcdn.com/ohwassets/HCI/Acme_Electric/Literature/SECTION-1.pdf
But how would I go about testing it without causing too much damage to soft tissue. H1,H2,H3 are all connected to winding #3 if I understand correctly.
It was given to me with a machine which has 380V motors ion it. Supposedly run from 220V 3 PH power supply. This last part I am not entirely sure of though.
X1,X2,X3 and Ground RED,BLACK,BLUE,GREEN) are from the original supply source on the primary coil.
Could it be #71 page 40 of this manual just run backwards as this shows X1,X2,X3 on # 3 instead of how its wired now on HQ,H2,H3 on #3?
https://hubbellcdn.com/ohwassets/HCI/Acme_Electric/Literature/SECTION-1.pdf