- Joined
- Mar 22, 2014
- Messages
- 847
I just bought a load of taps from a local retired machinist. I culled out what I need and now have the following spares:
1/2-13, 1/2-20, 7/16-14, 3/8-24, 3/8-16, 5/16-18, 1/4-28, 1/4-20, 10-32, 10-24, 8-32, 6-32, and some pipe taps. Most are Greenfield, I think they are HSS. There are taper, plug and bottom taps, also a few spiral taps. Most are lightly used and some may have never been used. I have just one or two spares of some sizes and over a dozen of other sizes.
I'd like to trade whatever taps that you might need for any of the following:
Chucking reamers, most all sizes below 1 inch
Lathe mandrels, 1/2 inch and 3/4 inch
Threading dies, 4-40, 2-56, 0-80, 1/4-32
Morse taper 2 hand reamer (for cleaning up a MT2 socket)
Thanks,
Jon
(revised - traded some taps)
1/2-13, 1/2-20, 7/16-14, 3/8-24, 3/8-16, 5/16-18, 1/4-28, 1/4-20, 10-32, 10-24, 8-32, 6-32, and some pipe taps. Most are Greenfield, I think they are HSS. There are taper, plug and bottom taps, also a few spiral taps. Most are lightly used and some may have never been used. I have just one or two spares of some sizes and over a dozen of other sizes.
I'd like to trade whatever taps that you might need for any of the following:
Chucking reamers, most all sizes below 1 inch
Lathe mandrels, 1/2 inch and 3/4 inch
Threading dies, 4-40, 2-56, 0-80, 1/4-32
Morse taper 2 hand reamer (for cleaning up a MT2 socket)
Thanks,
Jon
(revised - traded some taps)
Last edited: