Just wanted to chime in and say I went with the heated drill bit method. Been trying to save a bit lately so didn't want to spend on the right angle attachment.
I had a box of used misc drill bits so I used one of those as the victim. Pressed it against my shop propane heater grill for about 5 seconds and then just spun it by hand. Worked pretty good although it took about 3 'heat cycles' to do it and the hole didn't need to be accurate at all.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.