For some reason, my lathe does not have a witness mark on the threading dial housing. Where is the mark usually located on a grizzly? Does it matter? I'm assuming as long as you engage the half nut on the same number at the same spot each time?
For some reason, my lathe does not have a witness mark on the threading dial housing. Where is the mark usually located on a grizzly? Does it matter? I'm assuming as long as you engage the half nut on the same number at the same spot each time?
yep that's what I did on mine...Just start the lathe, lock in the halfnuts, and then shut off the motor. The you can scribe a line near any number you want.