Those are supposed to be precision bearings.
-
Welcome back Guest! Did you know you can mentor other members here at H-M? If not, please check out our Relaunch of Hobby Machinist Mentoring Program!
Teco VFD on Gorton mill help
- Thread starter Liljoebrshooter
- Start date
Those are all good bearings- set you back a good amount too I reckon
LOL
LOL
That's about $350 sitting there. That's a lot less than I was thinking it was going to be after I started this project. You can spend a LOT of money on bearings.
Joe Hynes
Joe Hynes
Better to do the job once and well, instead of cheaping out and re-doing it later
Mark
Mark