Hi, new her and the process or restoring an old Canadian drill press that has seem some pretty heavy use.
Any advice on how to get the chuck off. The collar is normally used to push it off. No luck when it was on the press either. Used a couple of wedges but just end up pushing up the collar on the shaft.
Was thinking about drilling and punching out. If I can push the collar up more will give me enough room to support the chuck.
Thanks,
Andrew
Any advice on how to get the chuck off. The collar is normally used to push it off. No luck when it was on the press either. Used a couple of wedges but just end up pushing up the collar on the shaft.
Was thinking about drilling and punching out. If I can push the collar up more will give me enough room to support the chuck.
Thanks,
Andrew