M
Mister Ed
Forum Guest
Register Today
I recently installed a TECO LMS510 VFD for my new Logan lathe. I placed a 220 on/off switch before the VFD to cut its power when not in use. Only one problem, I have the VFD out of site and more than half the time I don't remember to power it down when finished.
So, the question is, can I tap into the 12volt control power from the VFD to run a small 12 volt lamp when the VFD is powered on? Or would that cause issues? I am already tapped into that power source for the Forward/Stop & Reverse/Stop functionality.
So, the question is, can I tap into the 12volt control power from the VFD to run a small 12 volt lamp when the VFD is powered on? Or would that cause issues? I am already tapped into that power source for the Forward/Stop & Reverse/Stop functionality.