Screw thread for qcgb handle axle

[joebiplane]

OK Loganeers,
I am finishing up my Logan 825 and I have misplaced the screwy that goes into the right end of the axle that carries the two gear selector handles on the QCGB.
im pretty confident that it is a 1/4" diameter but is NOT a 1/4-20
Can someone give me the correct size and thread pitch ???

Would sure appreciate it
Joe

 

[Chuck K]

Joe, It's been a while since I've had my hands on a logan, but I think if the shaft is original it should be 1/4-20. It could be that someone has already replaced the shaft with one they made....so it could be anything. Have you tried threading a tap into the end of the shaft? The threads could just be jammed up a little.

Chuck

 

[CluelessNewB]

The parts manual says it is 1/4-20 x 1/2" and that is what my 820 has.