Rotary, and Milling Vises for G0704

[kd4gij]

I'm another 4" vise, 6" rotary table guy.

Bill

I do agree, The 9" RT was $40.00 I couldn't pass it up. It is a Troyke.

 

[wrmiller]

I do agree, The 9" RT was $40.00 I couldn't pass it up. It is a Troyke.

VERY nice!

Bill

 

[Just Startin']

My 2cnt.. I have the G0755 and with it's little bit bigger table the 5 inch vise does over hang when mounted with it's base, works better on some applications with out it's base. I went with an 8 inch rotary table as had read that a 6 is a little small. The one I have has 6 clamping slots in the table and that is a big plus. It fits on my table fine. To do it over I would get the 4" vise, will probably get a 3" screw less to compliment the 5".
Ron

 

[Gman45acp]

I have a 4 inch and like everyone else it is the right size for a 0704