I wonder if there are any sites that might discuss adjustments and modifications, I'd like to reduce the backlash on the axial movements but don't know where to begin.
X and Y have about .010 and .015 and I suspect there must be some way to tame this.
A few times I have tackled a prohect that would have been a lot easier with a right angle spindle drive. Is there one suitable for this bench top R8 mill.
Thanks, -Jay-
X and Y have about .010 and .015 and I suspect there must be some way to tame this.
A few times I have tackled a prohect that would have been a lot easier with a right angle spindle drive. Is there one suitable for this bench top R8 mill.
Thanks, -Jay-