I want to make a setting tool (punch) for 1/4" semi tubular rivets used to attach brake pads.
Is the anvil that supports the head inside the brake pad perfectly flat across the face and the same diameter as the rivet head?
What does the head of the other anvil look like? The one that cinches the tubular rivet. I can see poor photographs of setters that are for sale but can not find any suggestions on dimensions. There seems to be a small raised area in the center surrounded by a lower moat then a higher perimeter.
I am guessing there must be some kind of standard about what the finished cinch looks like?
Is the anvil that supports the head inside the brake pad perfectly flat across the face and the same diameter as the rivet head?
What does the head of the other anvil look like? The one that cinches the tubular rivet. I can see poor photographs of setters that are for sale but can not find any suggestions on dimensions. There seems to be a small raised area in the center surrounded by a lower moat then a higher perimeter.
I am guessing there must be some kind of standard about what the finished cinch looks like?