Measure the id (internal diameter) of the drive pulley.
John
John
He could use the pulley that is on it to make a bushing for the factory pulley.The Tag is a little hard to read but from what I can see:
Voltage = OK 115v
RPM = OK 1725
The Shaft Diameter is going to be the gating factor for you.
Will it fit your required Pulley?
that has the same specs as the motor on my SB 9.Can anyone tell me if this motor will work? Could pick it up for $40. Thanks!
View attachment 344455View attachment 344456View attachment 344457