W
WMello
Forum Guest
Register Today
Hi rwm,
I think this works like a taper attachment, but I have never seen one in action.
Curious to know how the cross slide is released on taper attachment.
On my lathe, just remove two screws and rotate the lead screw out.
This is just a one off part, so reassembling and adjusting the cross slide is not a issue.
Wagner
I think this works like a taper attachment, but I have never seen one in action.
Curious to know how the cross slide is released on taper attachment.
On my lathe, just remove two screws and rotate the lead screw out.
This is just a one off part, so reassembling and adjusting the cross slide is not a issue.
Wagner