- Joined
- Sep 8, 2019
- Messages
- 4,392
I am building a home for the R8 and 3/4” shank tooling for my knee mill. This will be a three level shelf, each shelf looking like a collet rack.
The shelves will each be a 14” X 14” square of 1/4” thick aluminum. I haven’t bought the aluminum yet because I am still saving up.
I am working on the three *frames* for the shelves with steel that I had laying around. Each shelf was made with 12 small pieces that I welded together.
Today I am side milling the edges of the steel shelves to make them flat & square.
The shelves will each be a 14” X 14” square of 1/4” thick aluminum. I haven’t bought the aluminum yet because I am still saving up.
I am working on the three *frames* for the shelves with steel that I had laying around. Each shelf was made with 12 small pieces that I welded together.
Today I am side milling the edges of the steel shelves to make them flat & square.