- Joined
- Mar 31, 2022
- Messages
- 3
I purchased this VFD to run a 2HP 3P motor on my lathe. This specific model is for 220v 1P input and 220V 3P output all at 60HZ.
I have read many threads on this website related to these Chinese VFD’s but none on this particular model. I have attached a copy of the manual.
Pages 9-10 list the configuration points and pages 12-16 include point descriptions. So far, I have entered the following parameters:
point 1@1, 2@60, 3@2, 4@1, 5@3, 6@2, 7@1, 8@10, 9@10, 10 thru 12@60, 13@0 and 14@60. The remaining points 15 thru 35 are at the Default Values.
As programmed, I am getting a fault code of OC-u (acceleration over current). Fault codes are listed on pages 18-19.
Any comments and recommendations will be greatly appreciated.
I have read many threads on this website related to these Chinese VFD’s but none on this particular model. I have attached a copy of the manual.
Pages 9-10 list the configuration points and pages 12-16 include point descriptions. So far, I have entered the following parameters:
point 1@1, 2@60, 3@2, 4@1, 5@3, 6@2, 7@1, 8@10, 9@10, 10 thru 12@60, 13@0 and 14@60. The remaining points 15 thru 35 are at the Default Values.
As programmed, I am getting a fault code of OC-u (acceleration over current). Fault codes are listed on pages 18-19.
Any comments and recommendations will be greatly appreciated.