- Joined
- Apr 25, 2018
- Messages
- 54
Hi All,
New to the forum and thanks for allowing me to join. I have been looking at both mills and lathes for the last couple months and to be quit honest my head is spinning. Trying to decide on good old used work horses or opt for new Chinese/Taiwan equipment, the list goes on and on and on........ Anyhow, my immediate question is this, can you install a power draw-bar on the PM-835S mill?
Thanks and God Bless,
Kevin
New to the forum and thanks for allowing me to join. I have been looking at both mills and lathes for the last couple months and to be quit honest my head is spinning. Trying to decide on good old used work horses or opt for new Chinese/Taiwan equipment, the list goes on and on and on........ Anyhow, my immediate question is this, can you install a power draw-bar on the PM-835S mill?
Thanks and God Bless,
Kevin