PM935TV Power Draw Bar Mounting Question

[bretthl]

I'm getting ready to build a power draw bar and am looking for suggestions on how to mount it to the top of the head. My initial thought was to use the three M6x1.0 socket headed cap screws (only longer) to hold the mounting plate. Will these stand the torque? I would like to avoid drilling additional holes the head if possible.

 

[mksj]

Yes, that is usually what they are made for.

Saunders Power Drawbar kit on a PM935TV

I installed a Saunders Power Drawbar Kit on my PM935TV. I like the simplicity and it works well. I discovered the kit a few weeks back and ordered one hoping to fit it to my mill. Saunders Machine sells the kit to fit a Bridgeport so I gambled that it would fit. I did have to drill an extra...

www.hobby-machinist.com

 

[kd4gij]

If you are using an impact wrench, the bolts should be fine

 

[bretthl]

Thanks guys.