1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  2. PLEASE: Read the FORUM RULES BEFORE registering!

    Dismiss Notice

pm25mv fix

Discussion in 'PRECISION-MATTHEWS' started by LEM, Jul 11, 2017.

  1. LEM

    LEM Active Member Active Member

    Likes Received:
    24
    Trophy Points:
    8
    City:
    Vancleave
    State:
    Mississippi

    -Return to Top-

    Got tired of turning the draw bar 9mm. Made my fingers sore. An epiphany happened. Why not use a socket and a thumb drive. Works terrific. R8 collets are tightened sufficiently. I do sometimes put the wrench on it but very seldom. You must use a 12 pt socket.
    mill-800.jpg
     
  2. T Bredehoft

    T Bredehoft Active User H-M Supporter-Premium

    Likes Received:
    1,314
    Trophy Points:
    113
    Location:
    Central Ohio
    City:
    St. Louisville
    State:
    Ohio

    -Return to Top-

    I made a knurled aluminum spinner within a week of getting my PM25. I still use two wrenches to loosen and tighten the collets.
     

Share This Page