• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.
  • NOTICE: There are two new video channel areas set up, one for staff, and one for subscribing members. You need to create a folder. Then add your media to that folder. Once added, you can cut and paste the code at the bottom right to embed the media into a post on the forum.

    It works very similarly to YouTube, except videos are stored on our server. Click Here For The Video Channels

[4]

PM1127 Feed Rod

[3]
[10] Like what you see?
Click here to donate to this forum and upgrade your account!

MSD0

Active Member
Active Member
Joined
Apr 22, 2015
Messages
193
Likes
39
#1
The other day I noticed that the power feed rod on my 1127 doesn't extend all the way through the bushing at the tail end of the lathe.
I know it's hard to see in the pic, but the end of the rod is about 0.6" (short) from the end of the bushing. The power feed works fine, but it just seems a little weird that it was built like that. Are they all like this?
 
[6]
[5] [7]