Whoa! A double jack .... back flip! Congrats. !
Strange, I was able to lift my 940M from the front with only the engine lift. I did this in an even tighter space, but I had taken the X-table off so that I could get it through a door etc. Maybe that let me lower the head a bit more? If you jump to this page, containing the photo of the mill, you will also see that I had caused the stand to be even higher by putting it on pretty good sized casters. (after I got it where I wanted it I blocked it off off the casters. When I want to move it, I slide my floor jack under the bottom plate, one side at a time, and lift if off of the blocks and back onto the casters.
Have Fun,
Dave L.
Strange, I was able to lift my 940M from the front with only the engine lift. I did this in an even tighter space, but I had taken the X-table off so that I could get it through a door etc. Maybe that let me lower the head a bit more? If you jump to this page, containing the photo of the mill, you will also see that I had caused the stand to be even higher by putting it on pretty good sized casters. (after I got it where I wanted it I blocked it off off the casters. When I want to move it, I slide my floor jack under the bottom plate, one side at a time, and lift if off of the blocks and back onto the casters.
Have Fun,
Dave L.
