B
BRIAN
Forum Guest
Register Today
I am trying to cut .6 mod 8 leaf pinions.
.
The blank is .234" and the depth.059" as recommended in the article I am following.
but I am ending up with a flat top on the leaves.should I cut deeper to eliminate the flat? its difficult to see when its all setup.
the photo was taken on a USB Microscope at 20x.
Thanks in advance.for any help
BRIAN.
.
The blank is .234" and the depth.059" as recommended in the article I am following.
but I am ending up with a flat top on the leaves.should I cut deeper to eliminate the flat? its difficult to see when its all setup.
the photo was taken on a USB Microscope at 20x.
Thanks in advance.for any help
BRIAN.
Last edited by a moderator: