Hi I am a newbie to this site and have recently transitioned from a toolmaker ( retired) to a hobby machinist.
I have been refurbishing a Maximat Standard and adding a taper attachment but the feed nut needs attention and it is a 15/32-10 am me thread. I could at last resort single point it but don't like doing that an such a small bore. Any suggestions on finding a tap??
Will post pics off tapper attachment when I decide on a proper finish.
Thanks
I have been refurbishing a Maximat Standard and adding a taper attachment but the feed nut needs attention and it is a 15/32-10 am me thread. I could at last resort single point it but don't like doing that an such a small bore. Any suggestions on finding a tap??
Will post pics off tapper attachment when I decide on a proper finish.
Thanks