- Joined
- Mar 14, 2014
- Messages
- 175
This is a project i've wanted to make for a while, I was watching some of Tubalcain's videos. He made one from a tuna can ( or cat food I dont remember exactly) and heres my take on a no spill oil can. I started with a 2 1/2" x 1 1/2 copper reducer, a 1 1/2 x 5/8 fitting reducer and some pipe. I split a piece of pipe and flattened it out to make the bottom
then I sweat a piece of 5/8 in the fitting reducer,
then i soldered the bottom on
then inverted the smaller reducer into the large reducer
heres the finished oil can.
I know its a little overkill, but I like it !!
then I sweat a piece of 5/8 in the fitting reducer,
then i soldered the bottom on
then inverted the smaller reducer into the large reducer
heres the finished oil can.
I know its a little overkill, but I like it !!