- Joined
- May 7, 2014
- Messages
- 776
Trying to read up on the 30 Taper options now that my Mill is home and tucked away. Was initially told that it was a 30 QC (Quick change) but then the YCM 30 manual notes that it is a 30 taper NST 7/24.
Of course the Wiki page and some others note that NST and NMTB are 1:1 About to buy the ENCO set here: http://www.use-enco.com/CGI/INSRIT?PARTPG=INLMKD&PMPXNO=952727&PMAKA=210-1029
20% off code GIFT14 code That's $29 apiece. Cannot beat that on ebay! (suggestions welcome if ya'll have a source too... Not ordering just yet. But close.
thanks everyone!
Jeff /CG.
Of course the Wiki page and some others note that NST and NMTB are 1:1 About to buy the ENCO set here: http://www.use-enco.com/CGI/INSRIT?PARTPG=INLMKD&PMPXNO=952727&PMAKA=210-1029
20% off code GIFT14 code That's $29 apiece. Cannot beat that on ebay! (suggestions welcome if ya'll have a source too... Not ordering just yet. But close.
thanks everyone!
Jeff /CG.