Here Ya go!
I hope this is enough info and I tried to get the measurements as close as I could using the actual part.
I have made 3 so far
(https://www.hobby-machinist.com/thr...in-your-shop-today.67833/page-427#post-829436)
And would like a nice set of drawings to fall back on should I decide to do some more.
Saw you other post and looks like it does go through all. The slots were not present in your other post. Do the slots go all the way to the face of the 2.8" disc?Also, is the 5/8" hole through the whole thing or only down to the level of the 2.80" disc?
Sounds good. Give a depth to the bottom of the slot and I'll get this finished up.I just checked and the bolt hole circle, as close as I can tell is 2.215 dia.
X ways.
The slot does not go all the way to the web
I'll run back to the shop and try to come up with a distance.
Thank You!!
I just want a nice clean drawing I can print, laminate and keep in a project book for future reference is all.