- Joined
- Jun 19, 2017
- Messages
- 83
Good morning,
I have a HiTorque bench mill, 5500. It's about 2 1/2 years old. Bought new from LMS.
It's always been a great little machine.
Today hit the power button, it came on, all is good.
I hit start and the spindle didn't move and in a few seconds there was an error message.
I tried turning the speed control all the way down, hit start and no error. Then when I advance the control, the spindle doesn't move and I get the error.
Reverse, same. Tapping mode, same.
Does anyone have any ideas as to what i need to check out?
thx,
Jim
I have a HiTorque bench mill, 5500. It's about 2 1/2 years old. Bought new from LMS.
It's always been a great little machine.
Today hit the power button, it came on, all is good.
I hit start and the spindle didn't move and in a few seconds there was an error message.
I tried turning the speed control all the way down, hit start and no error. Then when I advance the control, the spindle doesn't move and I get the error.
Reverse, same. Tapping mode, same.
Does anyone have any ideas as to what i need to check out?
thx,
Jim