- Joined
- Jan 13, 2014
- Messages
- 69
I picked this 12X36 CNC Project up in September
After months of fiddling, retrofitting, and installing a PMDX-126 and ESS controller in to the drive rack, Flipping the X Axis motor 180 degrees I had first movements a week ago. will not disclose at this time how much I am in to it the incomplete project cost me a bit under 1k I will give final figures when I cut first chips and add up receipts.
The drivers and Steppers are Microkinetics.
See Video Here.
Still have some minor work to do to it and some mach3 settings but every hours I spend I get 1 step closer to cutting chips.
After months of fiddling, retrofitting, and installing a PMDX-126 and ESS controller in to the drive rack, Flipping the X Axis motor 180 degrees I had first movements a week ago. will not disclose at this time how much I am in to it the incomplete project cost me a bit under 1k I will give final figures when I cut first chips and add up receipts.
The drivers and Steppers are Microkinetics.
See Video Here.
Still have some minor work to do to it and some mach3 settings but every hours I spend I get 1 step closer to cutting chips.
Last edited: