Is there a trick to removing the table? I took out the gibb and lead screw, I believe it is supposed to lift out at this point?
No matter where or at what angle it always hits the dovetail.
I have to remove my new rf30 from a basement to bring it home and the seller never used it as it was his grandfathers.
We are fumbling around trying to figure out the best way to get it out of there. Grandpa must have paid someone to get it down there in '98.
I am bringing over my engine hoist so we can get the mill off the stand and then get the head off. I think we'll just strap the head (and then base) to an appliance dolly to move it up stairs. Hesitating to remove the motor but might do it if needed.
No matter where or at what angle it always hits the dovetail.
I have to remove my new rf30 from a basement to bring it home and the seller never used it as it was his grandfathers.
We are fumbling around trying to figure out the best way to get it out of there. Grandpa must have paid someone to get it down there in '98.
I am bringing over my engine hoist so we can get the mill off the stand and then get the head off. I think we'll just strap the head (and then base) to an appliance dolly to move it up stairs. Hesitating to remove the motor but might do it if needed.