- Joined
- Nov 10, 2010
- Messages
- 189
Here is a link to pictures where I just installed a Teco 7300EV(En) V06 VFD to my Sheldon 0 mill. I'm taking 220 single phase to 220 3 phase with it. I used the mill fwd and reverse controls with the install. Also installed an external speed control and kill switch. I have since reinforced the pod that holds these controls with a metal bracket as the plastic conduit was a little too flimsy. When I figure out how, I will try to step by step explain what I did. While not as nice as some I've seen, maybe it will give someone an idea as it took me a couple of weeks just to take the plunge and get started.
http://s791.photobucket.com/albums/yy200/wbedwards/Mill VFD install/
be
http://s791.photobucket.com/albums/yy200/wbedwards/Mill VFD install/
be